Re: Set Join to value upon startup

Set the value of the analog join that the timer is on to 0 after the
first run somehow.
This sets the timer interval, and setting the interval to 0 means it
will never fire.

Jarrod

On 1/08/10 6:54 PM, Hickup wrote:
> Hello,
>
> close, but not quite. The timer is called every time the page is
> displayed. So every time I switch the orientation of the iPad, it is
> being called, "resetting" my set to the initial value. I was looking
> for a place where such a command is issued exclusively during the
> launch of the application, not every time the page is displayed.
>
> I tried assigning the timer to an interim join, which in turn is being
> watched by a feedback, but could not create something like an "IF" Add
> OnMatch, which will only set the target join if the interim is set AND
> no other set is TRUE.
>
> Kind regards,
> Frank
>
>
> On Aug 1, 4:05 am, Jarrod Bell<jar...@guilink.com> wrote:
>
>> Create a command, and set its value to anything (other than a space)
>> and check the optional set target box.
>> Then choose the join type and join number you want to set, and assign
>> its value.
>>
>> Now create a timer on the startup page (right click the portrait or
>> landscape node of the page) and add a new timer with a repeat count of
>> 1 and an interval of 1, and choose the command created above.
>>
>> This will call the command when the page first shows, causing the join
>> to change state.
>>
>> Jarrod
>>
>> On Aug 1, 4:44 am, Hickup<hic...@gmail.com> wrote:
>>
>>
>>> Hello World!
>>>
>>
>>> After finishing my control bar (including the "set" button which
>>> switches in between modes), need to set Join number 1 to true upon
>>> start of the iViewer application (because this will activate my first
>>> "set").
>>>
>>
>>> I could not find a way to make that happen yet. Any hints?
>>>
>>
>>> Kind regards,
>>> Frank
>>>
>

--
You received this message because you are subscribed to the Google Groups "CommandFusion" group.
To post to this group, send email to commandfusion@googlegroups.com.
To unsubscribe from this group, send email to commandfusion+unsubscribe@googlegroups.com.
For more options, visit this group at http://groups.google.com/group/commandfusion?hl=en.