Re: Registration Not Found?

Set the button on the home page to digital join 1 (serial join is not
necessary at this point it only pertains to changing the text on the
button) set simulate feedback to on.

Set your subpage digital join to 1

put a button on the subpage with digital join 1 and simulate feedbAck
to on

On Jul 4, 6:59 am, Jarrod Bell <jar...@guilink.com> wrote:
> Choose the page to flip to via button properties. Simple as that.
> Or you can assign a digital join to a page and when the join goes high
> the page will be flipped to.
>
> Jarrod
>
> On Jul 4, 6:16 pm, Kaavs <mkaa...@gmail.com> wrote:
>
>
>
> > Okay. My bad - I just added the device with it's reg.code. the error
> > message does not show up. Thanks Jarrod. :)
>
> > But I'm still stuck with the inability to switch between pages. Is
> > there a discussion thread / document / video explaining how I could do
> > it?
>
> > Regards,
> > Kaavs
>
> > On Jul 4, 12:07 pm, Jarrod Bell <jar...@guilink.com> wrote:
>
> > > You must register a device to enable subpages and page flips.
>
> > > Have you done this and entered the registration code into your GUI
> > > before uploading it?
>
> > > Jarrod
>
> > > On Jul 4, 6:03 pm, Kaavs <mkaa...@gmail.com> wrote:
>
> > > > Hi all,
>
> > > > First of all, if I'm going to write something silly, forgive my
> > > > innocence..still learning to get the hang of this designer and it;s
> > > > power in automation. K, this is what I intended to do:
> > > > 1. Create a button that when clicked, takes you to a sub page with
> > > > another set of buttons.
>
> > > > For example, if the start page had "music system" button, when clicked
> > > > should take you to a sub page with volume control, track changer, etc
> > > > buttons + a back to start page option.
>
> > > > To get it to skip between pages, this is what I did :
> > > > 1. Created a page, set it as default page (start page).
> > > > 2. Created a button on the portrait layout, set it's digital join as 1
> > > > and serial join as 2.
> > > > 3. Created a sub-page, dragged it under the portrait page of the
> > > > default page.
> > > > 4. Created another button in the sub-page and set the digital join as
> > > > 2 and serial join as 1.
> > > > 5. Saved the project, uploaded to the iPad.
>
> > > > The start page's button was there and when i touched it, I got a pop-
> > > > up that said:
>
> > > > <b> Registration Not Found </b>
> > > > <p>The loaded project does not contain registration data for this
> > > > device. Page flips and subpages are disabled. </p>
>
> > > > Where am I going wrong? Please help.
>
> > > > Regards,
> > > > Kaavs

--
You received this message because you are subscribed to the Google Groups "CommandFusion" group.
To post to this group, send email to commandfusion@googlegroups.com.
To unsubscribe from this group, send email to commandfusion+unsubscribe@googlegroups.com.
For more options, visit this group at http://groups.google.com/group/commandfusion?hl=en.