Re: Registration Not Found?

Okay. My bad - I just added the device with it's reg.code. the error
message does not show up. Thanks Jarrod. :)

But I'm still stuck with the inability to switch between pages. Is
there a discussion thread / document / video explaining how I could do
it?

Regards,
Kaavs

On Jul 4, 12:07 pm, Jarrod Bell <jar...@guilink.com> wrote:
> You must register a device to enable subpages and page flips.
>
> Have you done this and entered the registration code into your GUI
> before uploading it?
>
> Jarrod
>
> On Jul 4, 6:03 pm, Kaavs <mkaa...@gmail.com> wrote:
>
> > Hi all,
>
> > First of all, if I'm going to write something silly, forgive my
> > innocence..still learning to get the hang of this designer and it;s
> > power in automation. K, this is what I intended to do:
> > 1. Create a button that when clicked, takes you to a sub page with
> > another set of buttons.
>
> > For example, if the start page had "music system" button, when clicked
> > should take you to a sub page with volume control, track changer, etc
> > buttons + a back to start page option.
>
> > To get it to skip between pages, this is what I did :
> > 1. Created a page, set it as default page (start page).
> > 2. Created a button on the portrait layout, set it's digital join as 1
> > and serial join as 2.
> > 3. Created a sub-page, dragged it under the portrait page of the
> > default page.
> > 4. Created another button in the sub-page and set the digital join as
> > 2 and serial join as 1.
> > 5. Saved the project, uploaded to the iPad.
>
> > The start page's button was there and when i touched it, I got a pop-
> > up that said:
>
> > <b> Registration Not Found </b>
> > <p>The loaded project does not contain registration data for this
> > device. Page flips and subpages are disabled. </p>
>
> > Where am I going wrong? Please help.
>
> > Regards,
> > Kaavs

--
You received this message because you are subscribed to the Google Groups "CommandFusion" group.
To post to this group, send email to commandfusion@googlegroups.com.
To unsubscribe from this group, send email to commandfusion+unsubscribe@googlegroups.com.
For more options, visit this group at http://groups.google.com/group/commandfusion?hl=en.