Re: iPad - Pages different sizes

I have also run across some alignment issues. I am not sure if this is related but here it goes.

During my initial layout of this DVR control page, a subpage that controls the room volume was identical in size to the channel controls of the DVR control subpage. After switching to the new beta software, gui designer shows the subpage to be misaligned. However, the iPad looks great; no misalignment. See attached image of the two subpage items side by side.

On Thu, Jul 22, 2010 at 9:24 AM, Heath Volmer <hvolmer@gmail.com> wrote:

I just did another copy/paste of an entire page and it worked fine.
I'll see if it shows up again and take note of what may be happening.
Thanks.

On Jul 22, 6:35 am, Jarrod Bell <jar...@guilink.com> wrote:
> I've never seen this happen and it's never been reported before, so
> not sure what happened on your end.
> Sounds very strange to me.
>
> Jarrod
>
> On Jul 22, 12:31 pm, Heath Volmer <hvol...@gmail.com> wrote:
>
>
>
> > I discovered that the copy/pasted page was approximately 40 pixels
> > short.
>
> > I made a new blank page and copied all the controls from the short
> > page to the new page and everything was good.  Something about the
> > copy/paste malfunctioning?
>
> > Thanks, Heath
>
> > On Jul 21, 8:09 pm, Heath Volmer <hvol...@gmail.com> wrote:
>
> > > Working on my first project here.  Made up a basic page (source
> > > selection, volume) and it's working fine.  I then took that page,
> > > copied and pasted it and used it as the framework for another page.
> > > When I viewed the new page on the iPad, all of the buttons were in
> > > different places than they should be.
>
> > > Upon further inspection, I discovered that, when viewing on the PC,
> > > the first page I made is just a touch too big to fit inside the window
> > > in Gui Designer (scrollbars necessary) and the second page is small
> > > enough to fit in its window.  Odd...
>
> > > Any thoughts?  Thanks, Heath

--
You received this message because you are subscribed to the Google Groups "CommandFusion" group.
To post to this group, send email to commandfusion@googlegroups.com.
To unsubscribe from this group, send email to commandfusion+unsubscribe@googlegroups.com.
For more options, visit this group at http://groups.google.com/group/commandfusion?hl=en.

--
You received this message because you are subscribed to the Google Groups "CommandFusion" group.
To post to this group, send email to commandfusion@googlegroups.com.
To unsubscribe from this group, send email to commandfusion+unsubscribe@googlegroups.com.
For more options, visit this group at http://groups.google.com/group/commandfusion?hl=en.