Re: iPad - Pages different sizes

I just did another copy/paste of an entire page and it worked fine.
I'll see if it shows up again and take note of what may be happening.
Thanks.

On Jul 22, 6:35 am, Jarrod Bell <jar...@guilink.com> wrote:
> I've never seen this happen and it's never been reported before, so
> not sure what happened on your end.
> Sounds very strange to me.
>
> Jarrod
>
> On Jul 22, 12:31 pm, Heath Volmer <hvol...@gmail.com> wrote:
>
>
>
> > I discovered that the copy/pasted page was approximately 40 pixels
> > short.
>
> > I made a new blank page and copied all the controls from the short
> > page to the new page and everything was good.  Something about the
> > copy/paste malfunctioning?
>
> > Thanks, Heath
>
> > On Jul 21, 8:09 pm, Heath Volmer <hvol...@gmail.com> wrote:
>
> > > Working on my first project here.  Made up a basic page (source
> > > selection, volume) and it's working fine.  I then took that page,
> > > copied and pasted it and used it as the framework for another page.
> > > When I viewed the new page on the iPad, all of the buttons were in
> > > different places than they should be.
>
> > > Upon further inspection, I discovered that, when viewing on the PC,
> > > the first page I made is just a touch too big to fit inside the window
> > > in Gui Designer (scrollbars necessary) and the second page is small
> > > enough to fit in its window.  Odd...
>
> > > Any thoughts?  Thanks, Heath

--
You received this message because you are subscribed to the Google Groups "CommandFusion" group.
To post to this group, send email to commandfusion@googlegroups.com.
To unsubscribe from this group, send email to commandfusion+unsubscribe@googlegroups.com.
For more options, visit this group at http://groups.google.com/group/commandfusion?hl=en.