Re: iPad - Pages different sizes

Not sure exactly what I'm looking at there...
Can you send me the GUI project archive (File > Export > Project
Archive)

Jarrod

On Jul 23, 10:22 am, Nathan <goldschla...@gmail.com> wrote:
> I have also run across some alignment issues. I am not sure if this is
> related but here it goes.
>
> During my initial layout of this DVR control page, a subpage that controls
> the room volume was identical in size to the channel controls of the DVR
> control subpage. After switching to the new beta software, gui designer
> shows the subpage to be misaligned. However, the iPad looks great; no
> misalignment. See attached image of the two subpage items side by side.
>
>
>
> On Thu, Jul 22, 2010 at 9:24 AM, Heath Volmer <hvol...@gmail.com> wrote:
> > I just did another copy/paste of an entire page and it worked fine.
> > I'll see if it shows up again and take note of what may be happening.
> > Thanks.
>
> > On Jul 22, 6:35 am, Jarrod Bell <jar...@guilink.com> wrote:
> > > I've never seen this happen and it's never been reported before, so
> > > not sure what happened on your end.
> > > Sounds very strange to me.
>
> > > Jarrod
>
> > > On Jul 22, 12:31 pm, Heath Volmer <hvol...@gmail.com> wrote:
>
> > > > I discovered that the copy/pasted page was approximately 40 pixels
> > > > short.
>
> > > > I made a new blank page and copied all the controls from the short
> > > > page to the new page and everything was good.  Something about the
> > > > copy/paste malfunctioning?
>
> > > > Thanks, Heath
>
> > > > On Jul 21, 8:09 pm, Heath Volmer <hvol...@gmail.com> wrote:
>
> > > > > Working on my first project here.  Made up a basic page (source
> > > > > selection, volume) and it's working fine.  I then took that page,
> > > > > copied and pasted it and used it as the framework for another page.
> > > > > When I viewed the new page on the iPad, all of the buttons were in
> > > > > different places than they should be.
>
> > > > > Upon further inspection, I discovered that, when viewing on the PC,
> > > > > the first page I made is just a touch too big to fit inside the
> > window
> > > > > in Gui Designer (scrollbars necessary) and the second page is small
> > > > > enough to fit in its window.  Odd...
>
> > > > > Any thoughts?  Thanks, Heath
>
> > --
> > You received this message because you are subscribed to the Google Groups
> > "CommandFusion" group.
> > To post to this group, send email to commandfusion@googlegroups.com.
> > To unsubscribe from this group, send email to
> > commandfusion+unsubscribe@googlegroups.com<commandfusion%2Bunsubscribe@goog legroups.com>
> > .
> > For more options, visit this group at
> >http://groups.google.com/group/commandfusion?hl=en.
>
>
>
>  subpage_sizeIssues.png
> 93KViewDownload

--
You received this message because you are subscribed to the Google Groups "CommandFusion" group.
To post to this group, send email to commandfusion@googlegroups.com.
To unsubscribe from this group, send email to commandfusion+unsubscribe@googlegroups.com.
For more options, visit this group at http://groups.google.com/group/commandfusion?hl=en.