Re: NSXMLparseError domain error 65/ Amx module

There are two ports which provide different functionality:
1. Is the port where the GUI file is being served from
2. Is the port that the actual communication takes place on

In iViewer settings you enter the full path to the GUI file.
In guiDesigner project settings you enter the IP and port that your
AMX processor is listening on as per your program.

The 'intermittent connection' warning is due to heartbeat not being
replied to. This means either your guiDesigner project has the wrong
connection details or your AMX program is not setup correctly to reply
to heartbeats.

I am not an AMX programmer, so can't be of much more help.

Jarrod

On Jun 7, 12:54 am, Matteo Mancò <mpcb...@gmail.com> wrote:
> hello jarrod!
>
> i've worked on it !!
> i did a little steps ahead but not so much
>
> well :)
>
> i try to explain what i did, so maybe we can find my mistake (im sure
> that is a stupid mistake)
>
> -module version is the lastest
>
> -i modified the 'control system' properties in 'project properties'
> section in guidesigner with ip address of my amx processor and a
> communication port (es. 8090)
> -save project  :D
>
> -i added to my workspace the .gui file
> -i compiled the program in AMX compiler specifing the settings of my
> system ( naturally )
> -i send the program to my processor
> -start debugging mode.
>
> the risults are:
> ipod dont upload the gui (maybe i used the wrong path to .gui)
> after i uploaded the .gui with upload service....
> but ....the iviewer said me 'Experiencing intermittent connection'
> and....the diagnostic in Amx do not show me no heartbeat msg to try to
> wake up connection
>
> that s all
>
> can you help me?have you ever used iviewer with Amx?
>
> i read deeply the module and i still dont understand on which port
> ipod and amx have to communicate
> for me ...the problem is the communication port (maybe i forgot to
> write some specific parameter somewere in guidesigner or amx complier)
> what you think about that?
>
> thanks for your help!
> Jmt

--
You received this message because you are subscribed to the Google Groups "CommandFusion" group.
To post to this group, send email to commandfusion@googlegroups.com.
To unsubscribe from this group, send email to commandfusion+unsubscribe@googlegroups.com.
For more options, visit this group at http://groups.google.com/group/commandfusion?hl=en.