Re: Lutron RadioRa2 test

On Jun 20, 2010, at 10:38 PM, Fiasco <dgvollmer@gmail.com> wrote:

> ~(?i)DEVICE,9,87,9,(.*?)\.*
>
> On Jun 20, 9:22 pm, av_roller <avrol...@gmail.com> wrote:
>> Thanks for posting info Fiasco,
>>
>> Everything works good but had one question hoping someone can answer.
>>
>> My dimmer level feedback comes back with two decimals, 90.00 for
>> example. Is there a way to just capture the 90 without the .00?
>>
>> Thanks
>>
>> On May 10, 10:41 pm, Fiasco <dgvoll...@gmail.com> wrote:
>>
>>
>>
>>> RadioRa2
>>
>>> Your startup command should be:
>>> username\x0D\x0Apassword\x0D\x0A#MONITORING,255,1\x0D\x0A?DEVICE,
>>> 1,109,9\x0D\x0A
>>
>>> Typical ra keypad command
>>> #DEVICE,9,7,3\x0D\x0A
>>> (device, integrationid,button,press)
>>
>>> Feedback for keypad (find led state of button 7 above, LED is the
>>> button number +80)
>>> ~(?i)DEVICE,9,87,9,(.*)
>>
>>> Request feedback from a dimmer
>>> ?OUTPUT,6,1\x0D\x0A
>>
>>> Parse feedback from same dimmer (you could set this to set the value
>>> of an analog slider
>>> ~OUTPUT,6,1,(.*)\..*
>>
>>> Set dimmer to a specific level (you could assign the value of an
>>> analog slider [sliderval])
>>> #OUTPUT,6,1,[sliderval]\x0D\x0A
>>
>>> To do a keypad dimmer action you are going to want to create a macro
>>> press dimmer button
>>> #DEVICE,9,19,3\x0D\x0A
>>> second macro command (wait 300ms)
>>> #DEVICE,9,19,4\x0D\x0A
>>
>>> Set the repeat delay on the button in your gui interface that triggers
>>> this to repeat every 325 ms.
>>
>>> When you send commands in succession to your ra2 repeater you should
>>> do it at 50ms intervals. The RA repeater will ignore an incoming
>>> command until it is done parsing the current command. 50ms is enough
>>> time between commands.
>>
>>> --
>>> You received this message because you are subscribed to the Google Groups "CommandFusion" group.
>>> To post to this group, send email to commandfusion@googlegroups.com.
>>> To unsubscribe from this group, send email to commandfusion+unsubscribe@googlegroups.com.
>>> For more options, visit this group athttp://groups.google.com/group/commandfusion?hl=en.- Hide quoted text -
>>
>> - Show quoted text -
>
> --
> You received this message because you are subscribed to the Google Groups "CommandFusion" group.
> To post to this group, send email to commandfusion@googlegroups.com.
> To unsubscribe from this group, send email to commandfusion+unsubscribe@googlegroups.com.
> For more options, visit this group at http://groups.google.com/group/commandfusion?hl=en.
>

--
You received this message because you are subscribed to the Google Groups "CommandFusion" group.
To post to this group, send email to commandfusion@googlegroups.com.
To unsubscribe from this group, send email to commandfusion+unsubscribe@googlegroups.com.
For more options, visit this group at http://groups.google.com/group/commandfusion?hl=en.