Re: Lutron RadioRa2 test

~(?i)DEVICE,9,87,9,(.*?)\.*

On Jun 20, 9:22 pm, av_roller <avrol...@gmail.com> wrote:
> Thanks for posting info Fiasco,
>
> Everything works good but had one question hoping someone can answer.
>
> My dimmer level feedback comes back with two decimals, 90.00 for
> example. Is there a way to just capture the 90 without the .00?
>
> Thanks
>
> On May 10, 10:41 pm, Fiasco <dgvoll...@gmail.com> wrote:
>
>
>
> > RadioRa2
>
> > Your startup command should be:
> > username\x0D\x0Apassword\x0D\x0A#MONITORING,255,1\x0D\x0A?DEVICE,
> > 1,109,9\x0D\x0A
>
> > Typical ra keypad command
> > #DEVICE,9,7,3\x0D\x0A
> > (device, integrationid,button,press)
>
> > Feedback for keypad (find led state of button 7 above, LED is the
> > button number +80)
> > ~(?i)DEVICE,9,87,9,(.*)
>
> > Request feedback from a dimmer
> > ?OUTPUT,6,1\x0D\x0A
>
> > Parse feedback from same dimmer (you could set this to set the value
> > of an analog slider
> > ~OUTPUT,6,1,(.*)\..*
>
> > Set dimmer to a specific level (you could assign the value of an
> > analog slider [sliderval])
> > #OUTPUT,6,1,[sliderval]\x0D\x0A
>
> > To do a keypad dimmer action you are going to want to create a macro
> > press dimmer button
> > #DEVICE,9,19,3\x0D\x0A
> > second macro command (wait 300ms)
> > #DEVICE,9,19,4\x0D\x0A
>
> > Set the repeat delay on the button in your gui interface that triggers
> > this to repeat every 325 ms.
>
> > When you send commands in succession to your ra2 repeater you should
> > do it at 50ms intervals.   The RA repeater will ignore an incoming
> > command until it is done parsing the current command.   50ms is enough
> > time between commands.
>
> > --
> > You received this message because you are subscribed to the Google Groups "CommandFusion" group.
> > To post to this group, send email to commandfusion@googlegroups.com.
> > To unsubscribe from this group, send email to commandfusion+unsubscribe@googlegroups.com.
> > For more options, visit this group athttp://groups.google.com/group/commandfusion?hl=en.- Hide quoted text -
>
> - Show quoted text -

--
You received this message because you are subscribed to the Google Groups "CommandFusion" group.
To post to this group, send email to commandfusion@googlegroups.com.
To unsubscribe from this group, send email to commandfusion+unsubscribe@googlegroups.com.
For more options, visit this group at http://groups.google.com/group/commandfusion?hl=en.