Re: Lutron RadioRa2 test

Thanks for posting info Fiasco,

Everything works good but had one question hoping someone can answer.

My dimmer level feedback comes back with two decimals, 90.00 for
example. Is there a way to just capture the 90 without the .00?

Thanks

On May 10, 10:41 pm, Fiasco <dgvoll...@gmail.com> wrote:
> RadioRa2
>
> Your startup command should be:
> username\x0D\x0Apassword\x0D\x0A#MONITORING,255,1\x0D\x0A?DEVICE,
> 1,109,9\x0D\x0A
>
> Typical ra keypad command
> #DEVICE,9,7,3\x0D\x0A
> (device, integrationid,button,press)
>
> Feedback for keypad (find led state of button 7 above, LED is the
> button number +80)
> ~(?i)DEVICE,9,87,9,(.*)
>
> Request feedback from a dimmer
> ?OUTPUT,6,1\x0D\x0A
>
> Parse feedback from same dimmer (you could set this to set the value
> of an analog slider
> ~OUTPUT,6,1,(.*)\..*
>
> Set dimmer to a specific level (you could assign the value of an
> analog slider [sliderval])
> #OUTPUT,6,1,[sliderval]\x0D\x0A
>
> To do a keypad dimmer action you are going to want to create a macro
> press dimmer button
> #DEVICE,9,19,3\x0D\x0A
> second macro command (wait 300ms)
> #DEVICE,9,19,4\x0D\x0A
>
> Set the repeat delay on the button in your gui interface that triggers
> this to repeat every 325 ms.
>
> When you send commands in succession to your ra2 repeater you should
> do it at 50ms intervals.   The RA repeater will ignore an incoming
> command until it is done parsing the current command.   50ms is enough
> time between commands.
>
> --
> You received this message because you are subscribed to the Google Groups "CommandFusion" group.
> To post to this group, send email to commandfusion@googlegroups.com.
> To unsubscribe from this group, send email to commandfusion+unsubscribe@googlegroups.com.
> For more options, visit this group athttp://groups.google.com/group/commandfusion?hl=en.

--
You received this message because you are subscribed to the Google Groups "CommandFusion" group.
To post to this group, send email to commandfusion@googlegroups.com.
To unsubscribe from this group, send email to commandfusion+unsubscribe@googlegroups.com.
For more options, visit this group at http://groups.google.com/group/commandfusion?hl=en.