Re: Gauge for Integra w/GC=100

Brian, not sure if you have been following the thread on Hex Strings
and Analog joins

Using telnet this is what the onkyo sends with each change in state to
the volume (even if you use the volume knob)

ISCP\x10\x0A\x01!1MVL04\x1A\x0A
(ignore the "ISCP\x10\x0A\x01" that is for network commands)

As you can see the last char is line feed \x0A

So for the EOM in onkyo system properties use \x0A
To display/capture the volume feedback data use :

.*!1MVL(..).* or .*!1MVL(.*)\x1A.*

Create a new capture group for the Volume Display using the same regex.
The only difference is setting the data type to Serial.

All above is for the TX-NR5007 onkyo.

Hope this helps

Nahshon

On 31/05/2010 04:00, gchts wrote:
> I tried .*!1MVL(..).* and no luck. I also tried .*!1MVL(\w{1,2}\x1A
> no luck.
>
> I was not getting any data in the serial join. I tried creating a new
> serial feedback with just the .* and just (.*) in the regex and still
> get nothing back. It is like nothing is coming back. I know the
> wiring is correct because I get a response with Netlinx Studio.
>
> Brian
>
>

--
You received this message because you are subscribed to the Google Groups "CommandFusion" group.
To post to this group, send email to commandfusion@googlegroups.com.
To unsubscribe from this group, send email to commandfusion+unsubscribe@googlegroups.com.
For more options, visit this group at http://groups.google.com/group/commandfusion?hl=en.