Re: Need help trying to control Integra AV receiver

I have the Integra (Onkyo) RS232 specs if you need them.

The commands are straight ASC, no hex.

On Dec 17, 6:43 am, Jarrod Bell <jar...@guilink.com> wrote:
> Hi Richard,
>
> What PC software are you using to control?
>
> The correct command should be:
> 1PWR00\x0D
>
> Also try:
> 1PWR00\x0A\x0D
>
> The last one is what telnet would be sending.
>
> Also make sure you have "maintain constant connection" ticked in the
> system properties.
>
> Jarrod
>
> On Dec 17, 8:08 pm, wogboynz <richard.cas...@gmail.com> wrote:
>
>
>
> > I am trying to control an Integra 5.9 AV receiver via its TCP port. I
> > have set it to the following settings, 1p 192.168.1.17 and port
> > 60128.
>
> > I have these same settings in the commandfusion software, I can ping
> > the receiver from my PC. I think my problem is with the data I am
> > sending it, I am not too sure whether it should be hex or not. The
> > message to send it for zone 1 off is "1PWR00" with a Carriage Return
> > on the end. I have tried converting it to hex and sending the
> > following for the zone 1 off command I have tried
> > "\x31x50x57x52x30x30x0D" "\x31\x50\x57\x52\x30\x30\x0D" ""1PWR00"/x0D"
> > without the quotes except for the ones inside the last example. What
> > am I doing wrong?
>
> > I can control the unit via my own pc software by sending "1PWR00"
> > carriage return.
>
> > Any help would be much appreciated, I have control documentation for
> > integra codes/protocol etc if anyone wants to take a look at that.
>
> > Cheers,
> > Richard- Hide quoted text -
>
> - Show quoted text -

--

You received this message because you are subscribed to the Google Groups "CommandFusion" group.
To post to this group, send email to commandfusion@googlegroups.com.
To unsubscribe from this group, send email to commandfusion+unsubscribe@googlegroups.com.
For more options, visit this group at http://groups.google.com/group/commandfusion?hl=en.